“Traveling Frog”

1. Introduction

    This model is divided into three parts: one part is the house frame, which uses a layer height of 0.12 mm, while the other two parts are furniture, using a layer height of 0.08 mm.

    A 0.4 mm nozzle is sufficient; some parts require 502 glue for bonding.

    A new print configuration for the house frame has been added, significantly reducingthe printing time.

2. Printing Precautions

It is recommended to apply 3D printing spray or clean the print bed to ensure better adhesion of the parts to the build plate.

This is especially important for small parts, as their small contact area results in weaker adhesion.

Since there are many small furniture components, using 3D printing spray can improve the success rate of printing.

When assembling the model, it is more convenient to use tweezers.