Lucky Block
Mario
Super Mario
Piggy Bank
- 0.2 mm layer height, 2‑wall walls, 15% infill density
4-disc
PLA
Designer
17
5
The design is scaled precisely to fit a 100‑RMB note. If you find the overall size too large, you can scale it down proportionally—but since I’ve left a 6mm x 2mm magnet hole in the design, I recommend printing at half the original scale, which will reduce the magnet hole to 3mm x 1mm. As for the question mark area, different filaments have varying tolerances; some filaments may not slide in smoothly, so you can use adhesive to securely bond them together.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- 存钱罐-2.3mfDesigner
3.17 MB
2026-02-09
