Because Wang Xiayi’s model was scaled down quite significantly, the foot of the model tended to break easily when removing supports—after three test prints, the foot would snap off every single time while we were trimming the supports directly on the print bed (though it could be reattached using 502 glue). After optimizing the support structure and running one more test print, the foot no longer broke during support removal, and the supports came off relatively smoothly. Still, care is needed when taking the supports off.

Additionally, since the walls of the trash can are extremely thin, the internal supports remain visible when the model is illuminated from behind. If this bothers you, you can adjust the support settings to “Generate Only on Build Plate.”