USS Ronald Reagan Aircraft Carrier

Scale: 1:333. Model length: 998 mm.

(Note: If electric operation is not required, simply purchase the B7000 glue and M2.5x6mm screws, approximately 100 pieces. Additionally, you’ll need M2.5x10mm screws, about 40 pieces.)

Three electric catapults capable of remotely launching aircraft; two motorized hangar elevators with remote control; powered by two motors and steered by one servo.

(Suitable for educational purposes or display in stores and homes—please note that if submersion is required, additional sealing and ballast work must be performed independently.)

 Printing Tips:
Print Bed: Use a textured PEI sheet.
Material: PLA
Layer Height: 0.2 mm
Outer Wall Count: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be necessary. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI print bed to ensure strong adhesion, and make sure your filament is completely dry.
Special thanks to everyone who has followed, liked, downloaded, and supported this project!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.2mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!