When printing PETG in vase mode, ensure the print bed is clean to prevent warping and stringing.

When printing PETG in vase mode, ensure the print bed is clean to prevent warping and stringing.

When printing PETG in vase mode, ensure the print bed is clean to prevent warping and stringing.

For optimal results, it’s best to print on a smooth, polished print bed—this will yield an even smoother surface finish.

No adhesive is required; simply press the piece into place for secure installation. The magnetic light module is battery‑operated and features easy battery replacement.

Accessories:

1. Magnetic induction light, 10 mm in diameter LED Magnetic Light Module – 10mm Magnetic Induction Light for Anime Figurines, Nepal Bead Puzzles, Acrylic DIY Lighting – Taobao

2. Round magnets, sized D6 x 3 mm. If you prefer not to embed magnets directly into the ring, you can easily remove the magnet‑receiving cavities from the model design.

Installation Tips:

Since the ring face is printed using vase mode, we’ve added an inner layer to enhance structural integrity and optimize light refraction effects.

The tolerances between the inner and outer layers are extremely tight, so careful, gentle pressure is required during installation—using a bead‑pushing hammer is highly recommended.