The CC2 machine emits an odor when placed in the room. Upon noticing a screw hole at the exhaust vent, I used UG to design a custom hood that vents directly outside—simply purchase a 50mm exhaust duct and you’ll even receive a clamp as a free gift.

The two upper screws were originally used to secure the build platform during disassembly, while the two lower screws are the original mounting screws.

To ensure proper alignment and tight fit, the tolerance for the screw holes is extremely precise. If installation isn’t perfectly aligned, you can either enlarge the screw holes or drill and re‑ream them after assembly. Be sure not to fully tighten the screws right away; instead, snug them down first and then make the final tightening once everything is properly aligned.