Spinning Top
Gyro launcher
A spinning top that spins for quite a while.
Print Profile(1)
- 0.2 mm layer height, 2‑wall walls, 15% infill density
2-disc
PETG
Designer
3
1
Released 2026-06-23
The gyroscope was printed in two halves; each printer has its own tolerances. If the central pin is slightly oversized, you can scale it down to 98% and print it again. Applying a bit of glue will make the assembly even more secure.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Remixes must be shared under the same license
Models(1)
- 陀螺 (4).3mfDesigner
254.55 KB
2026-06-20
No more
