Y30 Transport Aircraft – Gundam Edition

Evolved from the Y20, featuring a longer fuselage, six engines, and an empennage design inspired by the AN-225.

The nose and rear cargo doors are openable, allowing you to load small tanks or armored vehicles. You can even stash some secret cash… hehe.

This print is available in two versions:

One is a single-color version.

The other is a multi-color version (requiring an H2C printer or a multi-head printer for faster printing and reduced material waste).

Printing Tips:
Print Bed: Use a textured PEI sheet.
Material: PLA
Layer Height: 0.2 mm
Outer Wall Count: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be necessary. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI print bed to ensure strong adhesion, and make sure your filament is completely dry.
Special thanks to everyone who has followed, liked, downloaded, and supported us!

============================================================================

Single cockpit, movable wings and canopy; glue required for assembly.

Parts can be placed inside and removed.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12 mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be needed due to material shrinkage and printing tolerances. Apply even pressure during assembly.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and confirm that your filament is fully dry.

Special thanks to all friends for your attention, likes, downloads, and support!