Model Parameters

The overall model height is 10 cm, and it can be printed without AMS; reducing the scale to 70% will also allow for normal printing.

Printing & Assembly Notes

1. The parts are designed with tolerances, so glue is required for assembly.

2. To ensure the desired transparency effect when using transparent filament, the infill density for the body should be set to 0; remove supports carefully. If using standard filaments, you can increase the infill to 8–15% to enhance structural strength.

3. The pointed five-pointed star on the hat does not need to be glued in place; it can be rotated.

4. The small white square part should be inserted into the small recess at the base to provide stable support for standing.