Originally, I only made this for myself, so I didn’t consider supports or waste material. But since I’ve uploaded it, I should still address a few issues here~

1. The supports are difficult to remove—you’ll need at least a pair of diagonal pliers. If you know of a better support strategy, please let me know!

2. The print took quite a long time. I tried tweaking the settings and the support configuration, but the final result wasn’t very satisfactory.

3. A lot of material ends up being wasted because there are indeed many supports.

Other reminders for everyone:

Please try to print when both the filament and the printing environment are in dry conditions. This will help prevent stringing and make the supports easier to remove.

When removing supports, try to hold the nearby leaves or branches firmly with your hand; otherwise they can easily get damaged.

If any parts break off during removal, once you’ve finished taking everything down, apply a tiny drop of 502 glue to the cut edge and hold it in place for about a minute to secure it.

That’s all! Looking forward to seeing everyone’s prints.

This is my first upload, so there may be some things I haven’t covered yet—please feel free to point them out!

My username is RB; I’ll keep updating the models, and if there’s strong demand, I’ll upload more.

Welcome to stop by anytime!

Thanks again!