Fish tank
Aquarium
Pets
Laddering
Print Bed
Turtle
- 0.16 mm layer height, 2-wall structure, 100% infill density
2-disc
PLA
Designer
3
0
A lotus-leaf-shaped turtle basking platform, consisting of three leaf-shaped elements and a supporting base.
The overall dimensions are approximately 22 cm wide, 20 cm deep, and 8 cm high; to adjust the height, simply scale the Z value of Model 1 (note: the two objects in Model 1 will be scaled together).
The print settings call for 100% infill, allowing the structure to sink to the bottom of the water. To conserve material, the support base is hollow; when submerging the piece, be sure to drain any water trapped in the base’s gaps by gently shaking it.
The three leaf-shaped elements and the support base are marked with numbers 1, 2, and 3 at their connection points. These should be inserted into the base in ascending order—from lowest to highest. If the order is incorrect, the leaves may not align properly, preventing your pet from climbing onto the platform.
Creating this design was no easy feat—thank you for your support.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Remixes must be shared under the same license
Models(1)
- 荷叶晒台-A.3mfDesigner
2.42 MB
2026-03-24
