Here is a HSW for the CC2. It is attached with 4, 8mm X 2mm magnets and supported by 2 hanging hooks that I created with a HSW insert. The hooks latch into the small gap at the top of the printer (seen in photos).

The hex grid itself is in 4 pieces with snap connectors. The connectors are quite small and may need some fine tuning with a razor blade for proper fitment. You could also just shave them off and glue them together if you would like. I recommend lightly welding them together with a soldering iron for maximum strength, just be careful not to alter the interior hex shape to much as you may render that hex unusable with a connector. 

Enjoy!