ironing test
calibration plate
3d printing calibration
flow rate test
slicer calibration
test pattern
- 0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
25
3
Description
Tired of ironing that comes out blobby, dragged, or just plain ugly? So was I. Most ironing calibration tests wastes filament printing giant plates covered in embossed numbers you only need to read once. This one lets you skip that entirely and just read the image in the documentation.
Each square on the plate is set to a different combination of ironing flow percentage and ironing line spacing. Print it, find the square with the cleanest top surface, and plug those exact values into your slicer. Done.
What's included:
- Ironing Test (No Numbers) .3mf — the clean version. Prints just the squares, saving you the filament and time of printing embossed labels. Use this one with the mapping image below.
- Ironing Test (With Numbers) .3mf — same plate, but with each square labeled if you'd rather have the values printed right on the model.
- Mapping image — shows which square corresponds to which flow % and line-spacing combo, so the no-numbers version tells you everything you need without the extra plastic.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
This work is licensed under a Standard Digital File License. Digital files have a strict non-commercial, personal use only license.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital file or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including remixes of this object). You can not host these files on other digital platforms, web stores or cloud repositories. The objects may not be used in any way whatsoever in which you charge money, collect fees.
Models(1)
- Ironing Test without numbers.3mfDesigner
1.74 MB
2026-09-04
