My drawer is not a multiple of 50cm, there was space for another half bin, so Halfstep was born.

These bins remain compatible with Multigrid and it's existing bins but add half size increments. This also gives more flexibility when designing bins as you can pick the closest 25mm size rather than 50mm. They maintain the threaded base and push fit connection of the Thread Base Bins.

This is only needed if you have small 0.5 wide bins that you wish to stop from moving in the grid. The positioner snaps into place (fully removable) and stops such bins from moving. This is great because you can use the normal Panel or Base Plate for the majority of your setup and add these where needed, which uses less plastic :-)



If you have space for an extra 25mm around an edge of your drawer use the Halfstep Panels to extend your grid.

License

This is distributed under the Multiboard license detailed here.