Dragon and Phoenix
Dragon
Phoenix
Cup
Unzip
- 0.2 mm layer height, 2-wall structure, 8% infill density
5-disc
PLA
Designer
2
0
Dragon and Phoenix Swinging Cup
A 13‑inch, stress‑relieving drinking glass designed specifically for group gatherings—easy to assemble with just a bit of glue for bonding. With a tolerance of ±0.2 mm, give it a light sanding if the fit feels too tight.
Before printing, be sure to thoroughly clean the PEI print bed to ensure optimal adhesion and verify that your printing materials are completely dry.
The model requires approximately 300 grams of material and takes around 15 hours to print.
For the Dragon and Phoenix design, PLA in a matte finish is highly recommended—this material provides ample support, though supports printed with other materials can be tricky to remove.
Use PLA with a layer height of 0.2 mm, 2‑wall walls, and set the acceleration to 1000 or lower across all axes.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
This work is licensed under a Standard Digital File License. Digital files have a strict non-commercial, personal use only license.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital file or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including remixes of this object). You can not host these files on other digital platforms, web stores or cloud repositories. The objects may not be used in any way whatsoever in which you charge money, collect fees.
Models(1)
- 龙凤摇摆杯.3mfDesigner
6.99 MB
2025-11-18
