Compatibility
Fully compatible with Elegoo Neptune 3 & 4 / Pro / Plus / Max.
There is a dedicated version for the Neptune 3 Series, as there is no cable for the additional cooler there.

Improvements
The model has a separate, stable holder for the cable of the auxiliary cooler (Neptune 4 series). The screw points have been significantly reinforced.

Save material
The length is ideal for routing both cables perfectly (see photos).
No contact with the print bed or the component to be printed! The flat cable has sufficient clearance.

Dimensions
There are three length dimensions for each series: 80mm, 100mm, 120mm
Please choose your desired verison.
I have had very good experiences with 100mm.

No additional screw required.

Printing
I printed in PETG. Use 20% gyroid infill. Print upright and use brim. No supports needed!

Installation
1) Unscrew the crippled original cable holder and keep the screw
2) Unscrew the screw which is screwed in from the underside.
3) Install the cable holder and use the screws of different lengths in the corresponding hole

Do you like my work? I would be very happy if you would support my work on Ko-fi.

Differences of the remix compared to the original

• The holder of the cable for the component auxiliary cooler was moved and the length changed
• The total length was adjusted
• Screw points reinforced
• Corners rounded