mac
macbook
macbook pro
laptop
wrist
sharp
laptop wrist saver (macbook)
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
10
1
Released 2026-02-21
My wrists used to hurt after a few minutes of using my laptop. this solved the problem. All you need is some double sided tape, or hot glue (I used hot glue, but good double sided tape is probably better)
The print is quick and uses minimal filament. you can print just one side in 6 minutes if you want to check the fit on non MacBooks.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(1)
- laptop wrist saver.3mfDesigner
76.10 KB
2026-02-19
No more
