Another great design by kijai! What minor changes did I make?

1. Cut off a lot of the base
2. Resized the stump and the roof to 190% so that a tea-light would fit
3. Added a rudimentary window to the door because... you know... tea-light... ;)
4. Added a 5mm spacer underneath the tea-light so that it would be, what is to me, a good height for the tea light to show out the windows and door.

Just be aware, I also had to drop the bottom of the roof below the bed of my slicer by .4mm otherwise not all of the bottom of the roof was on the table.

No supports, no rafts, 15% infill (YMMV). I made the roof with ESun PLA+ Pine Green and the stump with ESun PLA+ Brown. The tea-light is your ordinary, every day, dollar store tea-light.