After the initial wooden door I remixed, I wanted something more lean. this door is still functional, but only turns inside.

It is hower a little more in tune with the rest of the wooden tiles and walls.

I liked the wooden door a lot more for the vibe I was going for then the original Tudor door. I didn't want assembly by using fillament, so just glue 2 spots and your door is assembled!

Still a very easy assemly and print.

Update 4th of february 2025: Fixed the height of this model, it was off compared to the other wall-pieces.

Instructions for the openforge/openlock system:

• Print the tiles of your choice.
• Remove the small supporting pins on the sides.
• Print Openlock clips to connect the tiles.
• Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).
• Connect the tiles together.

The designer of the totally free, awesome and VERY complete series is Devon Jones, check out his profile => https://www.thingiverse.com/devonjones/designs