dinosaur
jewelry
trex
necklace
pendant
TRexRemix
T-Rex Necklace Pendant
Print Profile(0)
12
3
Released 2025-07-24
I printed this at .1 mm layer height to get the most detail. It took about two hours to print without support or raft.
I also did this at 80mm/sec print speed and 100mm/sec traverse speed. I would suggest slowing this down a bit more to capture all the detail.
I suggest that you also superglue the bottom half to the upper so it doesn't just pop right out.
TRexRemix
Originality of the Model
The author declares that this work is their personally shared model
Original creator:
ZippyMultirotors
Reprint source:https://www.thingiverse.com/thing:325081
This model is licensed under the following terms:
Credit must be given to the creator
Remixes must be shared under the same license
Models(1)
T-Rex-Remix-Necklace.stl
51.67 MB
2025-06-13
No more
