I didn't see a Hueforge for The Bride! and wanted to add it to my collection, so I attempted to make one myself. 

A few things to note: I primarily use PETG filament, so this doesn't have normal hueforge colors (looking at you, Jade White)

I'm printing on a Centauri Carbon.
You'll notice the orange in my example looks off. When I went to print, I discovered I didn't have enough of the Bambu HF Orange, and substituted with Elegoo Rapid PETG Orange which is more translucent. I was not happy when I realized my mistake. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 133.39x200.75mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm

The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

#000000 PETG BambuLab HF Black Transmission Distance: 0.8

#9ea2a2 PETG BambuLab Basic Gray Transmission Distance: 3

#f75403 PETG BambuLab HF Orange Transmission Distance: 3.5

#ffffff PETG BambuLab Basic White Transmission Distance: 3.5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #13 (1.12mm) swap to Gray

At layer #14 (1.2mm) swap to Orange

Border Only Colors from here until the end.

At layer #18 (1.52mm) swap to White for the rest.