usb
flash drive
brick USB flash drive cover various sizes
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
4-disc
PLA
Designer
6
0
Released 2026-01-05
I desing the cover with extra space to fit any USB flash drive. Just remove the original plastic cover, secure the board with hot gun glue (in my case I just melt some of the support from the print) to the desire position and glue the two half together.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- usb-case-.3mfDesigner
243.27 KB
2026-01-04
No more
