New Gutter down pipe (rain water) splash cover / drain Cover - stops leafs getting blown under the down pipe and water splash of the drain grating towards peoples feet. replaces the existing larger cover from previous drain type that get blow about and even driven over when cars park close the hosue.

printed in Elegoo Rapid PETG (blue)

the back piece slides around the pipe (app 68.7mm diameter drain pipe). Then place the front piece up against the back aligning the holes. Place the Sloted 5mm bolts through the holes and added the nuts. You can use the slim m5 nuts in the files of any loose fitting nut or any M5 nuts and Thread Socket Cap Head Screws as the hex head too close to the side wall.  I put 6mm holes in body as I had issues with holes printing verticaly without supports, orginal was planning on usuing M6, my the bolts snap due at the layer if the nut is too tight when printing vertical no need for supports M5 worked well screw driver slot worked well. 17mm if thread lenght seem to be a sweet spot for getting the nut on tight to body easly