the original design was great but i fort that it could be made to be more realistic so i added an engine and exhorts pipe to make it more realistic ( i am a where that the exhorts pipe starts in the rouge spot but normally it goes behind the front wheel and underneath the bike the out the back, so i decided to have it start from the side and where it stats is the spot that i decided to do) the seat frame has also been changed to have a bit more of an angle and be more pointy.

now to have a successful print supports are needed, after printing supper glue is needed so that once assembled it doesn't full apart, keep in mind do not glue the wheels to the axels so that the wheels still spin.

original upload on maker would same title and that and same username