Description:

While I was creating the previous bone hair clip, I created a few other alternatives (some functional, which I'll perhaps publish in the future, others less so and which I'll refrain from showing), such as this skeleton bun with a pin, so you can wear different hairstyles.

Printing Instructions:

The stand is already set up to meet the needs of the model.

Assembly Instructions:

The pin can be inserted by passing it through two of the multiple holes in the bun, adapting it to your hairstyle; the pin will not fit through all the holes (some are too small), and it cannot be threaded through the longer side because it is too short.

Post-processing:

The stand comes off fairly easily; you just have to be careful to pull only the support and not part of the bun.