I had a bad idea for improving my posture when drawing in bed and this is what came into existence an hour later.

NOTE: Prefer _a_flat.stl to _a.stl -- _a.stl originated as a test print for a more complex idea that turned out to not be necessary.

If the clip fits poorly, your slicer can easily stretch the model in the direction of tablet thickness without negatively affecting its printability or strength. If the clip extends too far past the device's bezel, it can easily be shortened with pliers. An extra extension flap above the rigging point is provided for attachment by glue, tape, or welding.

The interior section of the clip geometry in the model data is precisely 6mm thick (tablet thickness direction) and 7mm tall (bezel direction).

I am not responsible for any damage resulting from improper, unsafe, or inadvisable use.