Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

In print profile is model size 200x200mm, you can download also small STL 150x150mm.

Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.24mm and the Actual Depth is 2.24mm.

t is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used:
PLA Anycubic Black  Transmission Distance: 0.3
PLA Sunlu Meta Grey  Transmission Distance: 3.5
PLA Elegoo + Orange  Transmission Distance: 6
PLA Aurapol Beige  Transmission Distance: 2.4
PLA Elegoo Basic White  Transmission Distance: 7
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Grey
At layer #14 (1.2mm) swap to Orange
At layer #17 (1.44mm) swap to Beige
At layer #22 (1.84mm) swap to White for the rest.