The Design

Here's a fun Heart Fidget for Valentines, Built from the V3 Series (compatible)

In this Variation the Heart is laid flat, but still passthrough through the Outer Disc to make the heart appear from nowhere.

There's also a small hole to make it into a keychain.

Let me know if you experience any issues.
 

Assembly

Though not necessary, this toy is best enjoyed with some assembly.

The Method uses a small offcut of 1.75 diameter filament

Method :

1. Align hole in disc and hole in ball

3. Push piece of filament through and cut to length

4. Very Carefully Heat the end of the Hex key (Allen key) just enough to be able to melt filament, to then put on the filament to melt it flush

Printing

Please ensure your built plate is clean and your filament is dry - The surface area on the heart inner is quite low, so needs good bed Adhesion.

As long as everything is well tuned, no supports should be needed. 

Once printed let the build plate cool before trying to remove.
 

My Work

Thank you to everyone who has and is supporting me in my design work. A year and a half ago i never expected to be where i am today, and its all thanks to you!

Thank you for your support with likes and downloads. Thank you again!

If you enjoy my designs, please consider joining my Patreon:

https://www.patreon.com/RJ_Design