Software used:

Bilibili UPBig Fat Catopen-source softwareLumina-Layers

Materials used:

• Bambu PETG in white
• Bambu PETG in red
• Bambu PETG in yellow
• Bambu PETG in blue
• Bambu PETG in black
• Bambu PETG in gray

Printing details:

The model can be printed directly to completion.

From left to right, the prints were made using white–red–yellow followed by blue, then white–red–yellow with gray, and finally white–red–yellow with black.

The final appearance will vary depending on the materials and colors you choose; for more variations, feel free to experiment yourself.

Note:

• A 0.4 mm nozzle can also be used; all three prints were completed using a 0.4 mm nozzle.
• Be sure to level the heated bed before printing.

• The default flow rate for bamboo filament is set at 0.95, which may be too low; we recommend increasing it to around 1.1.

  

• You can scale the model as needed, but make sure the Z-axis height is not less than 1.68 mm; otherwise, the color layers may be compromised. Also, check the sliced file to see whether the first 1–5 layers have filaments that are too thin to extrude properly—if so, increase the flow rate.