Designed these covers to prevent dust and bebry to get into the axis screw bearing and bushing along with screw for rod. This makes a clean sleek look with minimal material and hassle.

 INSTRUCTIONS 

  * Front left cover, should snap right into place, firmly press into screw hole

  * Front right cover, if you don't have a camera should be same as a left side just snap in.

  + WITH CAMERA - you have 2 options, either utilize the notch to avoid all together or without the notch raise the camera up

  – NOTE: some users have brought to my attention if you have a camera without a light you should be able to slip the no notch easily, with a light would advise the notch or you'll need to adjust your camera height.

 * Rear cover, Not truly necessary as blower covers this area but there is a 3mm gap, youll need to remove the shroud to access this and press on.

01/24/2026 - UPDATE - 

• Added profiles for both notch and no notch under the camera “right side” this is the V2 profiles
• Added revised and updated profile “V3” this addresses the rear axis cover notches that overhang (cut back 12mm), camera cover has better fitment and follows camera contour better. Left cover didn't need any changes. Please use this profile for best fitment.