I created a model to keep a few spray cans on my Toolbox where i mounted a Skadis to.

This fits 2 spray cans with a diameter of about 66mm and 2 with a diameter of about 53mm. To me it looks like these to sizes are standardized in germany → most or all of my cans had these diameters.

I´ll store brake cleaner, WD40, Zinc-Spray and some rust remover there.

The print is meant to be printed on the edge at the front. this will give u a low amount of supports needed.

Go for 3 or 4 outer layers and infill as you like. Just make sure the hooks are filled completely for max strength.