This is a highly detailed model that has been optimized for easy printing. The model has been specifically tailored for 3D printing.
Printing Tips:
Print Bed: Use a textured PEI bed.
Material: PLA
Layer Height: 0.2 mm
Outer Wall Count: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be necessary. Apply even pressure when assembling the parts.
Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and make sure your filament is dry.
Special thanks to all friends who have followed, liked, downloaded, and supported this project!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.2 mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your filament is dry.

Special thanks to all friends for your attention, likes, downloads, and support!