GIF
filament
3d printing
10
0
Demonstration video (Filament Tangles - And how to stop them):
https://www.youtube.com/@3D_Dimensional/shorts
A clip to stop your filament from uncoiling.
Print settings:
Material: PLA
Layer height: 0.2mm
Infill density: 15%
Infill type: Gyroid, Cubic, or Cross-Hatch
How to use:
Slide flat part of clip over the spool and down, while the complex side is facing inwards. Next, push the filament through the other side until a click. To release filament, press down on the upside-down v shape.
Originality of the Model
The author declares that this work is their personally shared model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
Filament clip.stlDesigner
43.64 KB
2025-12-31
