Overview:

One of my hobbies is programming electronics, so I created a tray that I can move around as needed. The tray is made from ½” birch plywood that is carved out in the middle for Clickfinity plates by NoWarranty (https://www.printables.com/model/452675-gridfinity-clickfinity-baseplate-no-magnets-univer).  I designed this stand for my Kaiweets HT118A multimeter which was inspired by KaszpiR’s model:

https://www.printables.com/model/1208939-gridfinity-base-for-aneng-an8008-and-an8009-or-sim

It is a 2x2 Gridfinity grid based on Zach Freedman’s platform: https://gridfinity.xyz/.  There are two storage areas for probes and wiring or accessories.

Printing:

Print in any filament you wish.  No supports required.