I do most of my 3D parts cleanup/assembly while sitting on the couch in the living room. I needed an organizer to put on the coffee table so I don't have tools scattered all around. 

It has spots for the tools I seem to use the most. I'm sure I'll end up making a larger version as I add more tools.

Key features:

• A place to hold up to 4 pliers/snips. I always seem to need pliers that aren't already on the table so I wanted room for more than just a couple.
• Magnet inserts for the screw compartment on the side. This helps keep your screws from flying all over the floor when you knock the tool holder over while reaching for something else. Not that I've ever done that.
• Holes to hold screw drivers and allen wrenches.
• A compartment to hold whatever loose objects you may need to keep close by
• A spot for Loctite super glue
• A spot for a trimming tool
• A hole for sharpie, marker, pen, pencil, crayon, eyeliner, whatever else will fit.

• Any single hole holder from the Honeycomb Storage Wall can be used 

   

  Nothing special needed to print it. I used PLA with tree supports.