Low-profile Screw-on height adjustable feet

Need to slightly increase the height of a table, or just level it out? Try out these low-profile screw-on adjustable feet!

The feet are 50x50mm wide, and increases the height by a minimum of 31mm and is adjustable up to approximately 40mm. This is useful for increasing the height, but also very useful for leveling your table. The feet can be mounted underneath the table legs with up to 4 screws each. 

I have created two different versions of the adjustable feet, one being completely round, and one with edges making it easier to grip when adjusting, as well as giving the feet another look.

For one table you will need to print 4 sets, each consisting of a foot-base and a foot-screw.

Printing guide:

The tolerance between the base and the screws are quite tight, so you might need to scale the screws down a bit on the X- and Y-axis, if they're too tight.