Model Introduction:
This model is a paint shaker attachment designed to fit on a Theragun massage device. It was inspired by the need to efficiently shake Army Painter paints and other miniature paints commonly used for D&D minis, Warhammer, and other tabletop models. Traditional hand-shaking can leave pigments unevenly mixed, but with this attachment, you can achieve smooth, consistent paint every time.

Printing Requirements:

• Recommended material: PLA or PETG
• Layer height: 0.2mm
• Infill: 30-40% for strength
• Supports: Not required (if true, otherwise specify)
• Bed adhesion: Standard settings should work

Assembly Instructions:

1. Print the attachment.
2. Slide the printed part onto your Theragun head until it fits snugly.
3. Insert your Army Painter paint bottle into the holder.
4. Turn on the Theragun at a low-to-medium setting and let it mix your paints thoroughly.

Reprint Information:
This is an original design, not a reprint or remix of an existing model.