Sweet Treats – 3D Printed HueForge Bookmark

A delicious bookmark design that’s almost good enough to eat.

Cupcakes, coffee beans, and warm tones blend together in this cozy HueForge design. Perfect for foodies, coffee lovers, and readers who enjoy a little sweetness with every chapter.

🛠 Model Details

• Size: 42 × 140 mm
• Infill: 100%
• Layer Height: 0.08 mm (Base: 0.16 mm)
• Base Thickness: 0.48 mm
• Max Thickness: 2.48 mm
• Actual Thickness: 1.76 mm

🎨 Filaments Used

• Black: PLA Sunlu Black — TD: 0.1
• Dark Chocolate: PLA Bambu Matte Dark Chocolate — TD: 0.2
• Fire Engine Red: PLA Sunlu Fire Engine — TD: 4.3
• Pumpkin Orange: PLA Bambu Basic Pumpkin Orange — TD: 4.9
• Beige: PLA Bambu Matte Beige — TD: 3.5

This design uses 5 unique filaments.

⏸ Swap Instructions

1. Start with Black
2. At layer #9 (0.80 mm) → swap to Dark Chocolate
3. At layer #11 (0.96 mm) → swap to Fire Engine Red
4. At layer #14 (1.20 mm) → swap to Pumpkin Orange
5. At layer #17 (1.44 mm) → swap to Beige (for the rest)

🧵 Manual Swaps (No AMS Needed)

• In Bambu Studio or Orca, change swaps into pauses.
• At each pause: unload → load next filament → purge → resume.
• Keep 0.08 mm layer height for correct alignment.