Iqos Terea, Heets box with frame

Basic box, you can find skins for it below.

Can be printed without support.

No other parts are needed.

The top of the Terea-Heets box needs to be cut off and then it can be inserted into the box, no need to repack one by one.

It is a bit difficult to put together, you have to make sure it is in the open position and one side must be fully inserted first. Then carefully push the top out a little and insert the second axle.

0.4 nozzle with basic settings, with a 3mm skirt around for better adhesion, but this can be left out.

I printed with PLA.

There is a rim on the edges, so you can easily position the different skins for it: