Neptune
UBBI
Sensor hub
Toolhead
n4p
UBBI Toolhead Filament and sensor Hub
Print Profile(0)
81
3
Released 2025-08-14
This remix combines a LH-Stinger PTFE Hub with an integrated sensor and UBBI system. This modification enables toolhead filaments sensor functionality while maintaining UBBI system compatibility.
Required Parts:
- Adapter Mount (Choose one based on your setup):
- For Stock Neptune 4 Extruder:
- For SilencedFrost 3x5015 Fan Mod:
Print setting:
- PETG, ASA, ABS is highly recommended.
- Print with 0.12 layer hight, 3 wall, 95% infill, No support needed
Installation:
- First print and install the appropriate adapter mount for your setup
- Install the PTFE Hub with sensor
- Connect to your existing UBBI system
Release Note:
| Version | Note |
|---|---|
| V6 | Lower switch position for more accurate for the top 2 filament lanes. |
| V.2 | Raise bottom wall |
| V.1 | Remove Screw tabs, Optimized filaments flow reduce filament stuck on load/unload. |
| V.0 | Official Release. |
Bill of materials
- NameQuantityNotes
- 1Kailh Red GM 4.0 Microswitch or equivalent1
- 24mm Ball Bearing1unpack a 608zz
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
No Copyright.
Models(2)
UBBI Toolhead Hub (1).stlDesigner
1.15 MB
2025-08-11
UBBI Toolhead Hub.stlDesigner899.40 KB
2025-08-11
No more
