Contest
Reorganize Your Home Life
organizer
tapemeasure
Sewing
Maker
Soft Measure Tape Spool (No Supports or Hardware Needed)
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer5(1)
175
77
Released 2025-08-05
Description
An enclosed spool for a 13mm (0.5in) wide soft tape up to 150cm (60") comprised of four pieces: an inner and and outer top and bottom.
Assembly Instructions
- Place the inner bottom piece down on a flat surface.
- Fit the outer bottom piece over the inner bottom piece.
- Place the end of your soft tape into the slot on the inner bottom piece.
- Fit the outer top piece in place by pressing it into the matching groove on the bottom piece.
- Place the inner top piece onto the spool assembly, taking care to line up the slot for the end of the soft tape. Press firmly to secure.
NOTE: The pins on the bottom piece often break when attempting to take the inner pieces apart. Do NOT join the inner pieces until final assembly.
Originality of the Model
The author declares that this work is their personally remixed model
Original creator:
Peagler Science
Adaptation source:https://www.printables.com/model/798905-soft-tape-spool
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(5)
inner+top.stlDesigner
2.14 MB
2025-08-05
inner+bottom.stlDesigner1.72 MB
2025-08-05
outer-bottom.stlDesigner1.77 MB
2025-08-05
outer-top.stlDesigner1.58 MB
2025-08-05
- inner+bottom.3mf
1.81 MB
2025-08-07
View all(5)
No more
