🃏 Skeleton Ace – HueForge Multi-Color Bookmark

A skull. An ace. A swirl of gothic flourish. This design doesn’t whisper—it grins back from your book. Inspired by dark fantasy and tattoo-style linework, this high-contrast bookmark adds flair with every turn of the page.

Whether you're into shadowy tales or just want something a little extra dramatic between your chapters, the Skeleton Ace is a bold companion.
Perfectly tuned for HueForge and single-extruder printers—just follow the pause swaps and you’re good to go.

📏 Model Specs:

• Size: 42 x 145 mm
• Layer Height: 0.08 mm (with 0.16 mm base)
• Infill: 100% for crisp layering
• Max HueForge Depth: 2.3 mm
• Actual Depth: 2.4 mm
• Minimum recommended printable depth: 0.48 mm
• Supports: None needed
• Brim: Optional (but helpful)

🎨 Filaments Used (4 Colors):

• PLA Sunlu Black – TD: 0.3
• PLA BambuLab Tough Gray – TD: 1.8
• PLA BambuLab Silk Silver – TD: 0.4
• PLA BambuLab Jade White – TD: 5.0

🧵 Manual Color Change Instructions – No AMS Needed
This model includes pre-set pause points so any single-extruder printer can handle it like a pro.

1. Start with Black
2. At Layer #12 (1.04 mm) → switch to Gray
3. At Layer #14 (1.2 mm) → switch to Silver
4. At Layer #19 (1.6 mm) → switch to White (and finish)

📌 To add these pauses manually: In Bambu Studio or OrcaSlicer, go to the right-hand Layer Preview slider. Scroll to the target layer, right-click, and choose “Add Pause” to match the swap heights above.