Climb in (or out) of your dungeon using these stair-tiles.

I liked the original tiles a lot, but I didn't want to be puzzling when building my map. So I put some tiles together in these ready to go tiles.

Update 7th of January 2025: reïnforced the bases of 2 of the designs (1x4 and 1x4) to make them more sturdy.

Update 22th of January 2025: added sturdier base for easyer pin removal on the 2x2 tiles.

Remix of devonjones's OpenForge 2.0 Dungeon Stone Stairs
With the Openlock triplex base you can click the tiles together in a limitless configuration of your choice.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

Instructions:

• Print the tiles of your choice.
• Remove the small supporting pins on the sides.
• Print Openlock clips to connect the tiles.
• Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).
• Connect the tiles together.

Building your own dungeon? Try these components:

• Basic Tiles
• Corners
• Walls
• Walls with windows
• Pillars
• Brazier
• Stair tile going down
• Straight stairs going up
• Curved stairs going up
• Trap door tiles
• Gates
• Alcove
• Small pool/portal
• Tile with symbol

The designer of the totally free, awesome and VERY complete series is Devon Jones, check out his profile => https://www.thingiverse.com/devonjones/designs