Picnic / Beach / Camping can / soda holder.  Takes all size cans from Monster down to small Red Bull cans, all in one unit, no need for multiple prints.

The model includes TPU flaps to hold your can upright, however if you do not have TPU on hand or can not print with it for whatever reason, you can print them in PLA etc, and just slide them in position or back out to fit various can sizes.

If you would rather print the grass spike base all in one, I have included that too (will need supports).  If you prefer to print without supports, don't want to use the interchangeable bases, I have also included the grass spikes, with a flange suitable for gluing in place with super-glue etc.

For quick printing, using the offset screw base rather than the center screw base, but I have included both.

Uses the same ground screws / spikes as some of my other designs (Gassy Gripper), and intend to create more useful designs without the need to print extra bases all the time, just one set should do just fine.