I make this mechanical dragon for people who like cyberpunk style. Is very high detail with many gears and wires look. 

The best part is NO SUPPORTS and NO ASSEMBLY. You just print and it move right away when you pull off bed.

I work hard on the joints so they are not stuck. If your printer is calibrate good, it will wiggle very smooth. Good for put on top of your PC case or give to friend.

How to print:

• Wall line: 3 for make joints strong.
• Infill: 15% is okay.
• Layer: 0.2 is fine but 0.16 look much better for the small detail.
• Tip: If joints stuck, just wiggle a little bit hard. It will snap loose and be fine.

Enjoy the print!