Project: chainsawman.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.3mm and the Actual Depth is 2.3mm

Filaments Used:
    PLA SmartMaterials Orange Transmission Distance: 5.9
    PLA Anycubic Red Transmission Distance: 4.6
    PLA Sunlu Meta Black Transmission Distance: 1
    PLA Elegoo Sea Green Transmission Distance: 3
    PLA SmartMaterials Yelow Transmission Distance: 11
    PLA Elegoo White Transmission Distance: 9.6
This print uses 6 unique filaments

Swap Instructions:
    Start with Orange
    At layer #10 (0.96mm) swap to Red
    At layer #12 (1.12mm) swap to Black
    At layer #14 (1.28mm) swap to Sea Green
    At layer #16 (1.44mm) swap to Yelow
    At layer #22 (1.92mm) swap to White for the rest.

Note: for your Perphet alignment with other images in honeycomb mode download the guide

https://www.nexprint.com/en/models/ G0471687?printConfigId = G0369851

Every impulse helps me to continue creating new designs. I appreciate your support so much!

Don't forget to like it and save it so you can find it easily later!