Description:

A "not so small" chibi model of Bender Bending Rodríguez from Futurama. This model is slightly larger than my usual chibi models, and I strongly advise against reducing its size, as it will cause the print to fail.

The antenna on Bender's head, in particular, is very easy to not print due to its limited thickness; during initial attempts with the standard 7-8cm height, the antenna inevitably wouldn't come out, was completely distorted, or broke immediately.

Printing Instructions:

The support is already set to meet the model's needs.

Assembly Instructions:

No assembly required, as the model is made in one piece.

Post-processing:

The support around the body is fairly easy to remove; I just recommend being careful when removing the support under the body, not to apply excessive force forward, as this could bend the legs. The support between the teeth, however, will require a thin tool and a lot of patience.