• Resin type: Standard Resin (Elegoo Standard / ABS-Like works fine)
• Color: Any (details are not color-dependent)
• Elegoo mars 4 DLPP

Layer Settings

• Layer Height: 0.03 mm

  Key for sharp teeth and clean edges. 0.05 mm is acceptable, but this model benefits from 0.03.

• Bottom Layer Count: 6

Exposure Settings

(DLP needs much less exposure than LCD)

• Normal Exposure Time: 1.6 – 1.8 s

  Start at 1.7 s. Adjust only if under/over-exposed.

• Bottom Exposure Time: 20 s
• Light Intensity: 100% (default for DLP)

Lifting & Motion

• Lift Distance: 5 mm
• Lift Speed: 60 mm/min
• Retract Speed: 150 mm/min

Stable and safe for small detailed parts.

Anti-Aliasing

• Anti-Aliasing: ON
• AA Level: 4
• Gray Level: 2
• Image Blur: ON

This helps smooth the mouth curves and the stem.

Orientation

• Rotation:
  • 30–35° backward (mouth tilted up)
  • Slight side tilt (5–10°)

Never print this straight upright. The open mouth will trap suction and ruin the teeth.

Supports

• Type: Light supports
• Contact Diameter: 0.3 mm
• Contact Depth: 0.3 mm
• Density: Medium

Manual supports recommended, especially:

• Inside the mouth (lower jaw)
• Under the head
• Under the leaves
• One or two on the stem

Avoid supports touching the visible teeth tips.

Post-Processing

• Wash: 2–3 min (IPA 95% or better)
• Dry: Fully air dry
• Cure:
  • 2–3 min total
  • Rotate halfway