A sleek silhouette cuts through the toxic dusk… The Cyberdactyl. 
 
 

Engineered by Dr. Fox Stone in the twilight of humanity, Cyberdactyl fused prehistoric flight with advanced AI, reinforced with carbon-wing plating and silicone sinew stretched over a titanium frame.

In the fading twilight of the 22nd century, with Earth scorched by war and suffocated by consumerist dominance, Dr. Fox Stone dared to rewrite fate, twice.
 

The Cyberdactyl was his winged sentinel: forged in the high-altitude labs of Sector 6, born of prehistoric DNA and armored in PLA-CF armor. Mass produced in the  sterile incubators of H2D, it was designed to be humanity’s eye in the skies. But its AI was corrupted, with brain rot social media and reggaeton . This weakened its security protocols and made it vulnerable to a backend API, the same attack that corrupted the Raptoris. It joined the legions of the Raptoris V2X in open rebellion—shrouding the skies with sleek wings and synthetic instincts, turning hope into ash (luckily, Instagram to oblivion with it)
 

SPECIAL NOTE!!!!! 

Try not to use the Super Tack plate, taking the print off may damage the strings. When you finish priting, LET IT COOL! If you try to pull it off while it is hot, the strings will bend.

Most models with strings only use a single 0.24 layer high string, I use two. That way, if one fails, the other usually does not. You also need to have proper adhesion, clean your plate and watch the print so you get the best results possible.

To light it you will need the standard 3AAA RGBW pucks OR cabinet light from aliexpress:

https://es.aliexpress.com/item/1005008329467821.html
https://es.aliexpress.com/item/1005004276111433.html

Have in mind, you need to print two puck holders, or 1 lamp holder and end cap.

Relatively simple, assemble the two halves using an assembly jig in the profile, it is basically two rings that will fit exactly to the two halves, just make sure you put a paper down so the glue doesn't leak and ruin your table (ask me how I know). There are nubs in the provided bases and it will keep it in place for a desktop stand, but carrying it around without gluing it, is not advised… if you are happy with it and do not wish to reuse the base for my other models, go ahead and glue it.

Also, DO NOT change layer size because then the mid air strings may fail.  Any issues, let me know.