I based this on a night light made by the company Satco France in the 1960s-1970s. Should work with any standard puck light, I had these on hand so that's what I used. Assembly is simple, all you need is some glue and a couple cut off pieces of filament. Use one piece of filament cut however long you would like for the antenna, the base is glued onto the top of the head. Use another piece of cutoff filament in the hinge, for this it's easier to use a slightly long piece and then cut the ends once it's in. The body slides into the base of the head with a peg, if you look at the bottom of the body there are little impressions for where the legs get glued in so you can line up the body, legs, and face. For the nose I recommend holding it from the inside, putting a dot of glue in the round cover piece, and just pressing it on.  The little tab has a slot in the body it slides into so the head can be fully shut or propped open depending on preference. The eyes are easier to press in from the inside and just slide until they're even with the inside of the head. I painted mine but you can also just print it in whatever colors you like, the original had a few different colors it came in, it would be cool to see people make different colorways to fit their space.